Skip to content

NordShifts Edge

From advice to operations: the plan carried out at the plant, inside its own safety limits

NordShifts Edge is a small gateway at the heat plant. It reads the plant over OPC UA or Modbus, writes the day plan's power for electric boilers and heat pumps quarter-hour by quarter-hour, keeps running when the internet is down and sends the plant's measurements back, so every connected plant improves the forecasts.

See it work: a real day at a heat plant

A district heating plant with a heat tank, an electric boiler, a heat pump, a fuel boiler and the city network. Watch yesterday's real prices in your market decide, hour by hour, which unit makes the heat, or step through the gateway's control cycle.

Drag to turn the plant

The market's last complete day, planned for a reference plant. Each hour the plan compares the cost of heat from each unit, with grid fee and tax, and uses the tank to move heat to the dear hours.

Planning the day on the market's prices…

What could it be worth at your plant?

An estimate on your market's real hourly prices, with your country's fuel cost, electricity tax and grid fee, and your plant's heat demand from the local weather: how much more your electric boiler and heat pump save against fuel heat on a day-ahead plan than they do today.

How the units run today

Calculating on the market's prices…

The plant stays in charge of safety

The limits are set on site and live only in the gateway's own file. The platform sends plans; it can never change a limit. Any doubt hands control back to the plant's own control system.

  • Each unit's range, ramp rate, minimum on and off times and starts per day
  • The grid connection's import limit for all controlled units together
  • Heat supply first: below the supply temperature floor, electric heat is never reduced
  • Tank limits: no charging when it is full, no reduction when it is empty
  • Handback when data is older than a minute, the plant is in local mode or a setpoint does not read back
  • Stopping the gateway also hands control back to the plant

Shadow mode first

A new site starts in shadow mode: the gateway reads everything, decides, and writes nothing. Day by day the utility sees what the electricity actually cost and what following the plan would have cost. Control starts only when the utility agrees.

Works without the internet

Plans cover up to 36 hours and are kept on the gateway. When they run out, the site's chosen fallback applies: hand back to the plant, hold, or repeat yesterday's profile. Measurements wait on disk, about two weeks of them, and are sent when the link returns.

Built for NIS2 and the Cyber Resilience Act

  • Outbound HTTPS only: nothing calls into the plant network
  • Every plan is signed (Ed25519) and checked against keys pinned on site
  • OPC UA with SignAndEncrypt and certificate trust lists; passwords only in the environment
  • A software bill of materials (CycloneDX) with every release, and a published vulnerability policy
  • Least privilege: runs as its own user, with a read-only system and a local status page

Open core

The gateway is open source under the Apache License 2.0, so a utility can read every line that touches its plant. Paid modules plug into published interfaces.

Open source

  • Gateway, safety limits and controller
  • OPC UA and Modbus TCP connectors
  • Plant simulator and demo
  • Audit chain, buffer, status page and metrics

With a NordShifts subscription

  • Daily plans from the whole-plant optimiser and heat forecasts
  • Reserve activation through an aggregator
  • Certified profiles for specific boilers and heat pumps
  • Savings reports, audit checks and several sites in one view

Technical facts

ProtocolsOPC UA (Eclipse Milo), Modbus TCP
RuntimeJava 21, one 70 MB file, container or systemd service
HardwareIndustrial PCs, x86 or ARM
Control step10 seconds, plans in 15- or 60-minute intervals
MonitoringStatus page, health check, Prometheus metrics
LicenceApache License 2.0

Every plant makes the forecasts better

Connected plants send their measured heat, temperatures and unit power back. The platform also archives the ECMWF AI ensemble weather forecast every day, as it was issued, for each connected site. Models are then trained and tested only on what was known at the time.

Run it in shadow mode at your plant

A pilot starts with an hourly heat-meter export and the plant's sizes, then a gateway in shadow mode. The demo runs on any computer with Java: a simulated plant over OPC UA, a signed plan and the gateway carrying it out.

Try the demo

java -jar nordshifts-edge.jar demo

Write to [email protected]

NordShifts Edge: the gateway that runs a heat plant's day…